Scope Of Delivery; Instructions For Use; Preparation For Use - Ottobock 4R63 Gebrauchsanweisung

► Take suitable measures if required (e.g. cleaning, repair,
replacement, inspection by the manufacturer or a specialist
workshop etc.).
CAUTION
Exceeding the service life
Risk of injury due to change in or loss of functionality and damage to
the product
► Ensure that the approved service life is not exceeded.
CAUTION
Mechanical damage to the product
Risk of injury due to change in or loss of functionality
► Use caution when working with the product.
► If the product is damaged, check it for proper function and readi­
ness for use.
► In case of changes in or loss of functionality, do not continue
using the product (see "Signs of changes in or loss of functional­
ity during use" in this section).
► Take any necessary measures (e.g. repair, replacement, inspec­
tion by the manufacturer's customer service, etc.).
Signs of changes in or loss of functionality during use
Among other factors, changes in functionality can be indicated by an
altered gait pattern, a change in the positioning of the prosthetic com­
ponents relative to each other and by the development of noises.

4 Scope of delivery

4R63, 4R68, 4R100 Lamination Anchors
Fig. Item Quant­
ity
– – 1
1 – 1
Name Reference

Instructions for use

Lamination anchor
Fig. Item
1
The following parts are only for 4R63, 4R100:
1

5 Preparation for use

CAUTION
Incorrect alignment or assembly
Risk of injury due to damaged prosthetic components
► Observe the alignment and assembly instructions.
CAUTION
Improper assembly of the screw connections
Risk of injury due to breakage or loosening of the screw connec­
tions
► Clean the threads before every installation.
► Apply the specified torque values.
► Follow the instructions regarding the length of the screws and
about how to secure the screws.
5.1 Laminating the transtibial socket
> Required materials: 99B81* PVA bag, 623T3* Perlon stockin­
ette, 616B1* carbon fibre cloth strap, 699B1* fibreglass roving,
616G12* carbon fibre cloth, 616G15* carbon fibre woven stockin­
ette, 617H119* Orthocryl lamination resin 80:20 PRO
1) Pull a soaked PVA bag over the model. The PVA bag should be
sealed by heat welding at the distal end.
2) Pull two layers of Perlon stockinette over the model.
number
3) Place three layers of carbon fibre cloth (e.g. 15 cm x 15 cm) in an
647H86
offset arrangement on the distal end of the model.
–
4R63, 4R68, 4R100 Lamination Anchors
Quant­ Name
ity
2 – Lamination dummy
1 1 Lamination dummy
Reference
number
4X3
4X52
9