Acoms TECHNISPORT 2.4G II Bedienungsanleitung Seite 5

SAFE SET UP PROCEDURE
When the Transmitter is switched on it automatically
starts to search for free a band.
Once it is located it locks to it during this search.
The LED will initially blink once it has completed this
procedure and secured a band.
After it has completed, switch the transmitter and
receiver off and restart both.
Attention:
When there are many 2.4GHz wave devices
around, the search time may be longer.
When the receiver is switched on, it will also look for the transmitter which has the same ID. When it
finds the same ID, the LED will flash and when the band is fixed, the LED changes to a constant
light. ( Just like the Transmitter )
After it has completed switch transmitter and receiver off and restart both.
Attention:
When there are other 2.4GHz wave devices around, the scanning time may take longer.
If the receiver cannot locate the transmitter's signal or suffers from interference, the steering servo
will not function.
When the fail-safe function is off, the signal to the throttle channel is cut off.
This means that the speed controller throttle function or alternatively the throttle servo will not operate.
Both functions will revert to normal operation when the receiver obtains the correct signal.
If the receiver cannot obtain the signal from the transmitter after one second, the receiver will
automatically scan the bands to find the transmitter signal.
4
POWER
SWITCH