Whispbar K742W Montageanleitung Seite 8

EN
Fitting Kit
K742W
Fitment
Clamps directly to edge of roof under the
doors, pin locates in hole on vehicle
Please check the rear of this manual for
information relating specifically to your
vehicle.
Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
Tighten adjusting screw to 5 Nm (3.7 ft lb)
hand tight.
8