Silvercrest SFR 37 B1 Bedienungsanleitung Seite 16

BB*5$ B%ERRN 6HLWH  0RQWDJ  0DL    
Cutting long hair
Use the long hair trimmer|15 on the back of the shaver to shorten
your beard and sideburns.
1. Take off the protective lid|14.
2. Push the long hair trimmer|15 up.
3. Switch on the shaver with the on/off|6 switch.
4. After use, switch the device off, slide the long hair trim-
mer|15 back to its original position and clean the device
(Chapter "Cleaning and maintenance of the device" on
page 15).
Designer stubble
NOTE: depending on beard growth and shaving, the appear-
ance of a designer stubble can vary greatly.
To maintain a designer stubble look, shave dry with an attached
protective lid|14 regularly. In this case, the protective lid acts as
a designer stubble attachment.
• Shave your face as described in the chapter Dry shaving (Re-
chargeable battery and mains operation).
Cleaning symbol
The device's built-in timer adds up the shaving times. After a shav-
ing period of 30 minutes, the cleaning symbol|12 starts flashing.
It is a reminder to clean the device regularly. If you switch off the
device while the cleaning symbol is flashing, the timer will start
back at the beginning when counting the shaving time.
14
GB