Description Of The Appliance (Fig. 1) - eta Fenite Bedienungsanleitung

– Check regularly the condition of the power adapter inlet.
– Prevent hanging the power adapter cord loosely over desktop edge
where children may reach it.
– The power cord of the adapter must not be damaged with sharp or hot
objects or open fire, and must not be immersed into water or bent over
sharp edges.
– Please prevent adapter power cord from getting in contact with the
rotating parts of the appliance.
– If an extension cable is used, it must not be damaged and must comply
with the applicable standards.
– The batterie shall not be removed during normal operation. Only remove
the battery if the appliance is going to be disposed (see Section
V. ENVIRONMENTAL PROTECTION).
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
Electric foot file
A –
A1 – Switch 0/I, speed I or II
A2 – Light
A3 – Head arrestment button
A4 – Battery cover
B – Head/Roller (3 units)
C – Micro-USB cable *
D – Holder
E – Travel case
* Micro-USB cable: Use AC power adapter with USB or mobile power.
III. INSTRUCTIONS FOR USE
Before normal use of the appliance, the accumulator must be charged
(Fig. 2). The run time after charging depends on the appliance load, and
is approximately 90 minutes. Use the appliance with the connected power
USB cable other USB charger or mobile power.
Charging
– Please confirm the voltage of the external electric device is
5 V / 500 mA (at least) before charging it.
– Fully charge the appliance before using it for the first time or after no use
over a long period of time.
– Continuous charging will reduce the accumulator service life.
1) Make sure the appliance is off.
A5 – Power USB slot
A6 – indicator light (low speed)
A7 – indicator light (max. speed)
A8 – indicator light (low battery /
charging / charge complete)
25 / 58
GB