READ THIS BEFORE INSTALLING OR USING THE APPLIANCE
FAILURE TO OBSERVE THE INSTRUCTIONS BELOW MAY CAUSE DAMAGE OR SERIOUS
•Always unplug the appliance before commencing any service or maintenance.
• If either the mantelpiece or the appliance is damaged consult the supplier immediately and always before installing the
appliance with the mantelpiece and before using the appliance.
• Do not use the fire or the mantelpiece outside.
• Do not install the fire or the mantelpiece in damp surroundings or near a bath, shower or swimming pool.
• The hot-air outlet and cold-air inlet must not be blocked, either completely or partially, in any way whatsoever.
See fig. A.
• Neither the appliance nor the mantelpiece must not be fitted with an insulation blanket or packed in any other way.
• The appliance and the heating set (heating element, fan, switch and cable tree) incorporated into the mantelpiece is
suitable for 230V, 50Hz and has a maximum nominal load of 1400 Watt.
• The plug must remain accessible at all times after installation.
• The wall socket the fire-mantelpiece combination is connected to must be earthed.
• Do not position the mantelpiece and fire under the plug socket as the heat could damage it; you should also consider the
hot-air outlet in this respect, see fig. A.
• Never lay the mains lead anywhere near the hot-air outlet.
• Ensure that curtains and any other combustible materials are at least 1 metre away from the fire/mantelpiece
combination.
• We recommend that the fire/mantelpiece be installed by a qualified installer in accordance with the current regulations.
• Do not allow children or invalids near the fire without supervision and keep the remote control out of the reach of
children and invalids.
• Do not use this fire/mantelpiece combination with any other controls such as a timer, thermal regulator or programmed
controller to switch the fire/mantelpiece combination on automatically (the fire/mantelpiece combination could be
covered or someone could have moved it without you noticing), which could cause a fire.
• In the event of a failure, unplug the fire.
• Never hang wet clothes or towels, etc. on the heater to dry!
• If you leave the fire/mantelpiece combination and remote control on stand-by, a small amount of electricity will continue
to flow to the appliance.We recommend you use the on/off switch to switch the fire on and off.
• Do NOT use the fire/mantelpiece combination in an ambient temperature lower than 2ºC or higher than 40ºC.
• Do NOT use the fire/mantelpiece combination if the humidity is more than 80%.
• Do NOT use the fire/mantelpiece combination above 2000 m.
• N.B.:The appliance weighs approx. 30 kg, we therefore advise you not to move it unaided.
• N.B.:The mantelpiece weighs approx. 52kg, we therefore advise you not to move it unaided.
PHYSICAL INJURY
Important safety precautions
29
Saba SL