Web Interface; Status Indicator On Web Interface - Fronius Ohmpilot Bedienungsanleitung

Web interface

Status indicator
on web interface
Status
OK
Minimum temperature The minimum temperature has been exceeded. Heater 1 heats
Legionella prevention
Boost
Error
Temperature
Heat output
Heater 2
L2 heating element
L3 heating element
Ohmpilot is operating in normal mode.
up to 100%.
Legionella heating is active. Heater 1 heats up to 100%.
The Ohmpilot has been switched to boost mode manually. Heat-
er 1 heats up to 100%.
A fault has been detected. More information can be found on So-
lar Web.
Currently measured temperature. A valid value is only displayed
when a temperature sensor is connected.
Current power being used by the Ohmpilot.
Heater 2 is active. Heater 2 may be a second heating element, a
heat pump or an external source (e.g. gas-fired heating).
Phase 2 of 3-phase heating element is active.
Phase 3 of 3-phase heating element is active.
115