For the boundary between the teeth and gums
• Apply the brush head at a 45° angle.
After use
Cleaning the brush head and the main unit
1
Remove the brush head
• Rotate the brush
head to align its line
to the installation
position mark of the
main unit. (Pulling
out the brush head
while the brush head
is locked will lead to
breakage).
• Pull out the brush head vertically.
2
Clean the brush head.
Wash brush head using running
water.
• Thoroughly clean the inner and
bottom of brush head.
• Do not pull the bristle on brush head.
(Otherwise, it will lead to bristle
falling off.)
• Do not wash it with water higher
than 80 ºC. (Otherwise, it may lead
to brush head breakage.)
16
EW-DM81_ML.indb 16
45°
.
Pull out
Line
Rotate
Fixing position
mark
Installation
position mark
3
Clean the main unit.
Wash the main unit using
running water.
• Do not immerse the main
unit in water.
(Otherwise, the water may
seep into the main unit.)
• Do not wash it with water
higher than 40 ºC.
(Otherwise, it may damage
the main unit.)
4
Wipe off the water on brush head and main unit
for storage.
• Do not charge while it is wet.
Doing so may cause soiling.
2016-9-8 14:39:48