Language Selection - Motorola PMMN4095 Bedienungsanleitung

To avoid a possible explosion:
! !
•
DO NOT replace the battery in any area labeled
"hazardous atmosphere".
W A R N I N G
•
DO NOT discard batteries in a fire.
The Motorola-approved battery shipped with your WRSM is uncharged.
Prior to using a new battery, fully charge the new battery to ensure
optimum capacity and performance.
NOTE:
When charging a battery attached to a WRSM, turn the
WRSM OFF to ensure a full charge.
Battery Charger
To charge the battery, place the battery, with or without the WRSM, in a
Motorola-approved charger. When initially inserting the battery into the
charger, the charger's LED will turn red. DO NOT use WRSM until the
charger's LED turn Green,
The charger's LED indicates the charging progress; see Chapter 4 and
Chapter 5 or the label printed on the charger.
Align the slot of the battery with the charger's rail and slot in. Refer to
Figure 2.4.
4
English

Language Selection

Power ON the WRSM by pressing and holding Power Button until you
hear the language selection prompts.
Follow the procedure below if you want to reset to your desired
language.
Procedure:
1
Hold the Power Button for 6 seconds after the power up LED
indication illuminated to enter the language selection feature.
2
Select your desired language by pressing the PTT button. Refer to
Table 2.1 below for the Language Selection Indicators.
Table 2.1: Language Selection Indicators
State Power Indication LED
Language Selection LED illuminated
Voice Prompt
"For English press PTT
now" (Menu selection
prompts)