Inhaltsverzeichnis; Technical Data; How To Unpack; Cleaning The Filter Holder - Sartorius 16510 Bedienungsanweisung

Contents
1. Technical Data
2. How to Unpack
3. Cleaning the Filter Holder
4. Clarifying Filtration
5. Sterilizing Filtration
6. Microbiological Testing
7. Sterility Testing
8. Index to Recommended Accessories

1. Technical Data

Material
Sealing
Filter diameter
Prefilter diameter
Filtration area
Capacity
Connections
Operating pressure
Sterilization

2. How to Unpack

Remove filter holder from packaging. Make sure to remove
all parts.

3. Cleaning the Filter Holder

3.1 Completely disassemble filter holder (Fig. 1).
3.2 Clean all parts with a laboratory detergent which is
commercially available (for metal, glass, and synthetics).
3.3 Rinse parts with hot water first and then with
distilled water.
3.4 Dry parts using compressed air or drip-dry. Use of
towels or cloth to dry is not recommended since they
may leave lint particles on filter holder. If instructions for
cleaning are properly followed, the material of the filter
holder will remain clear, and your filter holder will always
be ready to use.
2
®
Makrolon (polycarbonate)
Polypropylene filter support
Silicone O-ring, 40 + 5 mm
(6980110)
47 mm
37 mm
2
12.5 cm
250 ml
Female Luer slip (3 each in the
lid of the funnel and receiver
flask, 2 on opposite sides of
the filter rest [table]).
2 hose nipples 6980234 for 10 mm
hose. Outlet of SM 16511:
20 mm outer diameter.
Vacuum or 2 bar pressure max.
Autoclave at 121°C