LaserLiner MetricStar Bedienungsanleitung Seite 8

Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning
agents, scouring agents and solvents. Remove the battery(ies)
before storing for longer periods. Store the device in a clean
and dry place.
Calibration
The measuring device should be calibrated and tested on a
regular basis to ensure it is accurate and working properly.
We recommend the measuring device is calibrated every
1 - 2 years. If necessary, contact your distributor or the
UMAREX- LASERLINER service department.
The zero setting must be checked prior to every
use by sliding the measuring jaws together.
Technical data
(Subject to technical changes without notice. 19W45)
Measurement range
Resolution
Accuracy
Power supply
Operating conditions
Storage conditions
Dimensions (W x H x D)
Weight
EU directives and disposal
This device complies with all necessary standards for
the free movement of goods within the EU.
This product is an electric device and must be collected
separately for disposal according to the European
Directive on waste electrical and electronic equipment.
Further safety and supplementary notices at:
http://laserliner.com/info/?an=AIV
08
EN
0 ... 150 mm
0.1 mm
± 0.2 mm
1 x 1.5V LR44 (AG13)
0°C ... 40°C, max. humidity
80% rH, no condensation, max.
working altitude 4000 m above
sea level
-20°C ... 70°C,
max. humidity 80% rH
240 x 80 x 16 mm
50 g (incl. battery)