Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Economizer
-ECON-
This function is suitable for repair works or
noncontinuous work where the soldering iron
remains unused for long periods of time.
Lowers the working temperature to 250°C, after
a preselected time of 1 to 99 minutes.
This function helps reducing tin oxidizing and
improves soldering quality results.
The setting programmed at the works is 0
minute, whereby the economizer is inactivated
(OFF message).
When the pre-set time has elapsed, the
message STANDBY appears on the display.
Press any key to return to the working
temperature and to reset the timer.
°C - °F Scale
Choice of units in °C (Celsius)
or °F (Fahrenheit).
Changing the LOOP / access to LOOP 1
>
Press key
YES if you wish to access LOOP
<
1, key
NO to change the access code, or the
MODE key to stay in LOOP 2 without making
any changes. This screen only appears when
the current access code is 10000.
Access code
Using
the
access
programmed data to be protected against
change by unauthorized personel.
code
enables
the
There are two access code categories:
-
NO PROTECTION
The code is 10000. It allows to modify all
data and move from one Loop to another.
This code is assigned at source.
-
COMPLETE PROTECTION
N u m b e r s b e t w e e n 0 0 0 0 1 a n d 9 9 9 9 9
(except 10000). In this category it is
essential to enter the access code before
any data can be modified. Does not allow
access to LOOP 1.
Entering the access code
If you are accessing this display for the first
time, you will first of all have to enter the fac-
tory-programmed one, i.e. 10000.
1) To enter the figure 1 press
>
2) Press
to move the first digit to the right.
3) To enter the first 0 press the
so on with the others. Press
The VALID message which comes up on the
display indicates that the number has been
entered correctly.
Then, the new password may be entered
following the same process.
If an attempt has been made to enter the
password and the number is wrong, it will wink
on the display. To enter the correct password,
push MODE until the enter display appears.
4
<
twice.
<
key once, and
>
to end.
Werbung
Inhaltsverzeichnis
