Makita UV3200 Original Bedienungsanleitung Seite 13

• Wear protective gloves before
performing
maintenance.
• The cutter does not stop
immediately after switch off. Wait
until all the parts stop before
performing any maintenance
work.
• Make sure that all the tools are
removed after maintenance
work.
• Never use gasoline, benzine,
thinner, alcohol or the like
for cleaning.
deformation or cracks may
result. To clean the machine,
use only moist cloth and soft
brush.
• Do not hose or clean the machine
with high pressured water.
When transporting the machine, pay attention to the
following points:
• Switch off the motor, unplug and wait until the cutting
tool stops.
• Adjust the depth of the cutting tool to transportation
height.
• Always transport the machine by its handle.
• Avoid heavy impact or strong vibration.
• Secure the machine firmly in case it is embarked on
vehicles.
Perform the following steps after each operation:
• Switch off the motor, unplug and wait until the cutting
tool stops.
• Clean the grass catcher. Store it in a dry room.
• Check, clean and store the machine in a dry room.
Perform the following work at regular basis:
• Check all the clamps, such as screws, nuts etc. are
tightly fasten.
• Check for defects such as loose, worn, or damaged
parts. Replace them if necessary.
• Check that the covers and guards are not damaged or
deformed.
• If the machine starts vibrating abnormally during
operation, that may be caused by unbalanced or
deformed cutting tool due to the impacts by foreign
objects. Have the cutting tool repaired or replaced by
authorized service center if it happens.
• The cutting tool is worn out during the course of time.
Check the condition of the cutting tool and its stability
on regular basis. Replace it if it is worn or become blunt.
• Clean and lubricate all screw parts before storage.
inspection
Discoloration,
or
13