Technical Data; Installation - Zanussi ZOB593 Benutzerinformation

Problem
The oven lamp does not oper-
ate.
Steam and condensation col-
lect on the food and in the ap-
pliance.
The display shows or
, the appliance does not heat
up and there is no air circula-
tion.
The display shows the error
code "F...".
If you cannot find a solution to the problem yourself, con-
tact your dealer or the service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

Technical data

Voltage
Frequency

Installation

Warning! Refer to "Safety information" chapter.
34
Possible cause
The fuse in the fuse box is released.
The oven lamp is defective.
You left the dish in the appliance for too
long.
Demo mode is on.
There is an electronic error.
Do a check of the fuse.
If the fuse is released more than one
time, contact a qualified electrician.
Replace the oven lamp.
Do not let the dishes stay in the appli-
ance for longer than 15-20 minutes after
the cooking is completed.
Deactivate the appliance. Press
approximately 2 seconds. An acoustic
signal sounds. Press and hold the but-
tons
the acoustic signal sounds and the indi-
cator goes out.
Write down the error code and contact
the Service Centre.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
.........................................
.........................................
.........................................
230 V
50 Hz
Remedy
and at the same time until
for