Steaming; Cleaning And Care; Cleaning The Main Unit; Cleaning The Accessories - Silvercrest SDR 1100 C2 Bedienungs- Und Sicherheitshinweise

NOTES:
The product takes around 3 minutes to preheat .
The product has to be unplugged
– after use,
– before cleaning, and
– before maintenance .
˜ Steaming
m
WARNING! The product has to be maintained
in an upright position
– while being used,
– under pressure or
– filled with water .
Hold the product by its handle 6 .
Push the child safety lock 4 to the
Gently press the steam trigger 5 . Release the
child safety lock 4 .
NOTES:
Controlling the steam output: Gradually press the
steam trigger 5 .
Stop steaming when the steam indicator 17 goes
off . Wait until the steam indicator 17 lights up
again . You may now resume with the work .
If there is no steam output – although the steam
indicator 17 is on: Disconnect the power plug 7
from the mains socket . Refill the water tank 2 .
˜ Cleaning and care
˜ Cleaning the main unit
m
DANGER! Risk of electric shock! Before
cleaning and maintenance: Disconnect the power
plug 7 from the mains socket .
m
WARNING! Do not immerse the product's
electrical components in water or other liquids .
Never hold the product under running water .
Wipe down the product with a slightly damp
cloth .
Do not let any water or other liquids enter the
product interior .
Do not use any abrasive, aggressive cleaners or
hard brushes to clean the product .
After cleaning: Let all parts dry completely .
˜ Cleaning the accessories
Clean the accessories in warm, soapy water .
After cleaning: Let all accessories dry completely .
Cleaning the cotton cover 10
position .
The cotton cover 10 can be hand-washed in
water with temperature up to 60 °C .
After cleaning: Let the cotton cover 10 dry
completely . You may also use a tumble dryer at a
low level (55 °C) .
˜ Removing limescale
If the steam power reduces drastically, it may be
needed to remove the limescale from the water tank
2 /accessories:
Water tank 2 :
Disconnect the power plug 7 from the mains
socket .
Fill the water tank 2 with a mixture of tap water
and vinegar (ratio of 2:1) .
Wait 24 hours .
Drain the mixture into a sink .
Flush the water tank 2 with fresh water (see
"Filling the water tank") .
GB/CY 13