Switching On/Off; Spraying Process; Servicing And Cleaning - Parkside PFSPS150 Bedienungs- Und Sicherheitshinweise

Advice on use / Maintenance and cleaning / Disposal
Example of
material
Car body paint
Acrylic paint
Synthetic resin paint
Primer

Switching On/Off

Q
Switching on
j
To start the device, press the ON/OFF switch
and keep it pressed.
3
Switching off
j
To switch off the device, release the ON/OFF
switch .
3

Spraying process

Q
The surface to be sprayed must be clean, dry and
free of grease.
Observe the safety advice!
1. You can vary the spray by adjusting the regulator
button (see Fig. D). The spray is correctly
2
set when no drops are formed and the gun
produces a fine, consistent spray pattern.
2. Do not switch the device on or off over the
area being sprayed. Begin and end the spray
process approx. 10 cm beyond the area being
sprayed.
3. The spray process should follow the sequence
shown in Fig. E – keep the spray gun moving
parallel to the surface
– Do not incline the spray gun
– Move the spray gun at a constant speed
– Apply the sprayed medium as thinly as possible
– The layer(s) of sprayed medium need(s) to
be allowed to dry for some time before you
apply the next coat Fig. F) at right angles to
the previous coat.
4. Do not allow the paint cup to empty complete-
ly while spraying – drops may form!
10 GB/IE/CY
DIN guidance
value
16-20 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
25-30 DIN-sec
Maintenance and cleaning
Q
General advice
WArNING!
1.
fore you carry out any tasks on the spray gun.
Do the same when you take a break from spraying.
2. After each use, spray thinners (in the open
air only – danger of explosion!) or
water through the device.
3. To protect from rust after cleaning, you can
spray sewing machine oil through the device.
4. WArNING!
in the cleaning medium.
5. Never use inflammable solvents to clean the
device.
Cleaning instructions
1. Unscrew the attachment screw
2. Take off the pump housing
3. Unscrew nozzle
8
pressure valve .
9
4. Take the pump piston
the pump housing
10
5. Clean parts ,
4 5
6. Fit the components back in reverse order.
Disposal
Q
The packaging is wholly composed of
environmentally-friendly materials that can
be disposed of at a local recycling centre.
Do not dispose of electrical
power tools with the household
rubbish!
In accordance with European Directive 2002 / 96 / EC
(covering waste electrical and electronic equipment)
and its transposition into national legislation, worn
out electrical power tools must be collected separately
and taken for environmentally compatible recycling.
Contact your local refuse disposal authority for
more details of how to dispose of your worn out
electrical devices.
Pull out the mains plug be-
Never immerse the device
, see Fig. A.
1
downwards.
10
and remove the suction-
and spring out of
4 5
.
, , with thinners.
8 9