BORETTI CFBG903AN Montage- Und Gebrauchsanweisung Seite 216

GAS TAPS
Periodic lubrication of the gas taps must be
carried out by specialist personnel only.
In the event of operating faults in the gas
taps, call the Service Department.
INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down.
The cavity should be cleaned using a
mild detergent solution and warm water.
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations and
testing a small sample of the oven cavity.
Abrasive cleaning agents or scouring pads/
cloths should not be used on the cavity
surface.
NOTE: The manufacturers of this appliance
will accept no responsibility for damage
caused by chemical or abrasive cleaning.
Let the oven cool down and pay special
attention no to touch the hot heating
elements inside the oven cavity.
BURNERS
They can be removed and washed with
soapy water only.
They will remain always perfect if cleaned
with products used for silverware.
After cleaning or wash, check that burner-
caps and burner-heads are dry before
placing them in the respective housings.
Check that the electrode "S" (figs. 8.1,
8.3) next to each burner is always clean to
ensure trouble-free sparking.
Check that the probe "T" (figs. 8.1, 8.3) next
to each burner is always clean to ensure
correct operation of the safety valves.
Both the probe and ignition plug must
be very carefully cleaned.
Note: The electrode "S" must be very
carefully cleaned. To avoid damage to
the electric ignition do not use it when
the burners are not in place.
216
CORRECT REPLACEMENT OF THE
AUXILIARY, SEMI-RAPID AND RAPID
BURNERS
It is very important to check that the burner
flame distributor "F" and the cap "C" has
been correctly positioned (see figs. 8.1 -
8.2) - failure to do so can cause serious
problems.
CORRECT POSITION OF THE DUAL
BURNERS
The burner must be correctly positioned;
failure to do so can cause serious problems.
Fit the flame spreader to the housing as
shown by the arrows (see fig. 8.3).
The burner correctly positioned must not
rotate (fig. 8.4).
Then position the cap "A" and the ring "B"
(figs. 8.4, 8.5).