Stryker SDC Ultra Bedienungsanleitung Seite 17

SDC Ultra™ Networking
Protocol Used: FTP (File Transfer Protocol)
Setup Requirements
1. A TCP/IP network.
2. A secure FTP (FTP over SSH) server may be installed and configured, if
needed. Ultra does not support FTP over SSL.
Instructions
1. Enter the IP address of the FTP server (and not the SDC Ultra™) into the
SDC Ultra™ Network tab in the Config menu.
2. Create a folder named SDC in the default path of the FTP Server. In
this folder, create a folder for the username. For example, if you have
anonymous FTP service running on a server with an IP address of
10.2.101.26, and you have a folder called JOHND in the SDC folder
in the default path of the anonymous login, then you should enter
10.2.101.26 in the network tab as the FTP address and JOHND as the
username.
Press Add so that SDC Ultra™ will remember the username and the FTP
3.
address in the list. SDC Ultra™ can remember up to 500 usernames and
FTP addresses.
Select the Write Videos check box on the Network tab if you want to
4.
write videos to the network.
To save the images and videos, press the Save to Network button
5.
from the Save menu. A confirmation screen will display. Check the
Anonymous Login checkbox.
Note The SDC Ultra™ checks the server for a response. If it gets a valid
response, it performs an anonymous FTP login. It then changes
directory to the directory corresponding to the current username
(JOHND, in current example). It does not create a new directory
based on the username. This avoids creation of multiple directories
if someone accidentally enters a wrong/invalid username. Therefore,
you have to enter a username for the FTP to work.
11