Wall Mounted Charger (Optional); Operation - Parkside PWSA 12-LI A1 Originalbetriebsanleitung

GB MT
flange (
clamping flange (
cess generally points to the attach-
ment tool and thus to the cutting/
grinding disc (2).
5. Press the spindle retaining tab (4)
and tighten the clamping screw (3)
using the Allen key (11). You can
now release the spindle retaining
tab (4).
If the direction of rotation is marked
on your cutting/grinding disc, make
sure that it matches the direction of
rotation mark on the tool.
Wall mounted charger
(optional)
You can also mount the charger (15) on
the wall.
• Using dowels, place two screws
54 mm apart at the desired posi-
tion of a wall.
• The screw head can have a dia-
meter of 6 - 10 mm
• Leave the screw heads protru-
ding at a distance of approx. 10
mm from the wall.
• With the openings of the wall
bracket, you can attach the char-
ger (15) to the two screws and
pull the charger down until it
stops.

Operation

Caution! Risk of injury!
- Only use grinding tools which
bear information about the
manufacturer, type of binding,
dimension and permitted number
of revolutions.
94
17). The side of the
17) with re-
- Only use grinding discs where
the printed rotational speed is at
least as high as what has been
specified on the name plate of
the device.
- Do not use any broken, cracked,
or otherwise damaged grinding
discs.
- Never operate the device wit-
hout protective equipment.
- Support the plates or workpieces
in order to reduce the risk of
kickback from a jammed cutting
disc. Large workpieces may
bend under their own weight.
The workpiece must be suppor-
ted on both sides of the disc, not
only near the cutting disc, but
also at the edge.
Keep your hands away
from the disc when the de-
vice is in operation. Risk of
injury.
Information on replacement:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed sta-
ted on the grinding disc (
the same or higher than the nomi-
nal rotation speed of the device.
• Ensure that the grinding disc dimen-
sions match those of the device.
• Only use flawless grinding discs
(ringing test: when you strike the
grinding disc with a plastic ham-
mer, it results in a clear sound).
• Never re-drill a locating hole which
is too small to make it larger.
• Never use separate bushings or
adapters in order to make grin-
ding discs with a hole that is too
large fit the device.
11) is