Werbung
4
Instructions for Use
General Information
General Information
This equipment is destined for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
persons, non-authorised interference with the equipment or any
action contrary to that provided for by specific national standards.
The MicroVac is a high voltage and low power feeder used to feed the
ionic pumps; it is equipped with a microprocessor used to control the
front panel.
In addition to the connector to feed the pump, there is also a jack
acting as an interlock; if it is not inserted into the output connector,
no voltage is present.
The following paragraphs contain all the information necessary to
guarantee the safety of the operator when using the equipment.
Detailed information is supplied in the section "Technical
Information".
This manual uses the following standard protocol:
WARNING!
The warning messages are for attracting the attention of the operator to a
particular procedure or practice which, if not followed correctly, could lead
to serious injury.
The caution messages are displayed before procedures which, if not followed,
CAUTION!
could cause damage to the equipment.
The notes contain important information taken from the text.
NOTE
40/72
MicroVac Controller User Manual / 87-900-089-01 (G)
Werbung
Kapitel
