VOLTCRAFT Ultimate 400 W Bedienungsanleitung Seite 85

• With the „INC" button, you access the next setting (or with the button „DEC" the previous
setting or return to the main menu with the button „BATT TYPE/STOP".)
NiMH Sensitivity
D.Peak 10mV/Cell
Here you can set the sensitivity of the delta-U detection of NiMH battery (voltage
difference in the delta-U charge procedure).
A value which is too high may overcharge the battery but if the value is too low, the
battery may not be completely charged.
Briefly push the „START/ENTER" button. The voltage value then begins to flash.
With the buttons „INC" or „DEC", you can set the desired voltage value (5....20 mV). If
you select „DEFAULT", the charger uses a voltage of 7 mV.
Save the setting with the „START/ENTER" button, the voltage stops flashing.
• With the „INC" button, you access the next setting (or with the button „DEC" the previous
setting or return to the main menu with the button „BATT TYPE/STOP").
NiCd Sensitivity
D.Peak
Here you can set the sensitivity of the delta-U detection of NiCd batteries (voltage
difference in the delta-U charge procedure).
A value which is too high may overcharge the battery but if the value is too low, the
battery may not be completely charged.
Briefly push the „START/ENTER" button. The voltage value then begins to flash.
With the buttons „INC" or „DEC", you can set the desired voltage value (5....20 mV). If
you select „DEFAULT", the charger uses a voltage of 12 mV.
Save the setting with the „START/ENTER" button, the voltage stops flashing.
Default
85