Rollei HS Freeze 4S Anleitung Seite 25

Quick Menu
Press the second function button from the top and turn the power output
CH
button to adjust the channel number . This can be set from 00 to 15 .
Press the third function button from the top and turn the power output button
GR
to adjust the group . Here you can choose between A/B/C/D/E/F/G/H/I/J .
Press the fourth function key from above for two seconds to activate RT
ID/RT
mode . Then press the fourth button again briefly to set the Canon* ID
between 00 and 99 . The Rollei HS Freeze 4s and a Canon* (RT) flash can be
synchronized if the channel and ID are the same .
Press the second function button from the top to activate the beep . Here
you can turn the function on and off . If this is turned on, the flash will make
indication sounds and the icon is shown on the display .
Infrared Slave Mode: Press the third function button from the top side to
activate or deactivate the slave mode function . If this function is activated,
the icon will be shown on the display . The flash is then able to release a
flash strobe as soon as another flash is fired . For this function the infra red
sensor should not be hidden .
Modeling lamp: Press the fourth function button from the top to activate
the modeling lamp . Press it once for the proportional mode [
the modeling lamp's intensity will match the power setting on the flash
unit . Press the button again to enter the independent mode [
in which you can set the power of the modeling lamp individually from
1 .0 to 9 .0 by turning the power output wheel . To deactivate the modeling
lamp press the Power on/off button .
ID/RT
25
PRO] and
1 .0 ~9 .0]