Initial Operation; Installing The Device - VOLTCRAFT Charge Manager 2005 Bedienungsanleitung

A memory effect is not caused (the charging current is pulsed). Thus, a high internal
resistance of the accumulator decreases and its current carrying capacity increases.
The efficiency of the accumulator is improved (ratio of the required quantity of cur-
rent to the capacity that can be delivered).
The charging set does not have a memory backup. In case of power failure the char-
ging process starts anew.
If an accumulator exceeds ca. 80% of the capacity it can take up during the rechar-
ging process, a portion of the charging current will be converted into heat. This can
heat up the accumulator.

Initial Operation

Since the device generates heat when operating, ensure that it is
adequately ventilated. The housing must not be covered!

Installing the device

Look for a suitable place close to a mains socket.
The charging station can be set up on a stable and horizontal surface.
Use an appropriate base support to protect the surface of your furnitu-
re. Softener-solvent substances contained in furniture preservatives
could etch the rubber feet of the charger which then in their turn could
damage your furniture.
Connection
If required, remove all accumulators inserted, connect the charging manager and
activate the POWER switch at the back of the device to switch it on. All the ten light
emitting diodes are turned on one after the other and then go out simultaneously.
In this period of time the charge managers performs a self-test.
Now, insert one MONO (R20) or BABY (R16) accumulator centrally in one of the four
twin compartments for round cells or insert one MIGNON (R6) or MICRO (R03) accu-
mulator at the edge of the twin compartments. You can also insert a 9V compound
accumulator in one of the two provided charge compartments.
Always observe the correct polarity.
19