Troubleshooting; Technical Specifications - Velleman VTSS110 Bedienungsanleitung

How to Clean a Tip?
• Set the temperature to 250°C.
• After the temperature has stabilized, clean the tip and check its condition. If the tip is deformed or badly worn,
replace it. If the solder-plated part of the tip is covered with black oxide, apply fresh solder containing flux and
clean the tip again.
• Switch off the unit and remove the cooled tip with the heat-resistant pad. Remaining oxides such as the yellow
discoloration on the shaft can be cleaned with isopropyl alcohol. Store the tip in a cool and dry place.
Recalibrating the Soldering Iron
• The soldering iron should be recalibrated each time you replace the soldering iron, heating element or tip.
• Connect the unit to the mains.
• Set the temperature control knob to 400°C.
• Switch on the unit and wait for the temperature to stabilize. Remove the CAL pot plug.
• After temperature stabilization, use a small Phillips-headed screwdriver and turn the CAL screw (clockwise to
increase, anticlockwise to decrease) until the tip thermometer reads 400°C. Replace the pot plug.
CAUTION: Disconnect the unit from the mains prior to examining and maintaining. Failure to
do so may result in electroshocks.

6. Troubleshooting

Problem
The heater LED does not light
The heater LED lights but the tip
does not heat
The tip heats up intermittently

7. Technical Specifications

Power Supply
Dimensions Station
Total Weight
Soldering Iron
Power Consumption
Temperature Range
Input Voltage
Heating Element
Hot Air Gun
Power Consumption
Temperature Range
Air Capacity
Heating Element
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
VTSS110_v2
Possible Cause
Not connected to the mains
Blown fuse
Soldering iron cord defective
Defective heating element
Oxidized or unclean tip
Badly calibrated soldering iron
Defective tip
230VAC / 50Hz
187 x 128 x 246mm
5.8kg
60W
200°C ~ 480°C
24V
PTC
450W
100°C ~ 500°C
23l/min
metal heating core
4
Solution
Connect to the mains
Determine the cause of the blown
fuse, replace the fuse
Have your dealer replace the cord
Have your dealer replace the heating
element
Clean the tip
Recalibrate the soldering iron
Replace the tip
VELLEMAN