USER GUIDE
Charging from the USB charging port
You can charge your device through the USB socket on this unit with a USB cable
(not supplied).
• The maximum current for USB charging is 1A.
• All devices for USB charging are not guaranteed.
Network Connection
This product only supports wireless network connection for network access and did
not support wired LAN connection.
Wireless network
1. Check first of all whether the control lamps (LINK/ACT) of your router light up.
2. Proceed with the operations described in the below "Initial Set-Up". It is re-
commended to run through the setup wizard in the System Settings section.
» This unit cannot be connected to a standalone modem directly. A router
or a modem incorporated with a router has to be used. Since there are
various connection configurations, please follow the specications and
instructions of your telecommunication carrier, Internet service provi-
der, and router setting guidebook.
Initial Set-Up
When you first connect the unit to the mains socket, the display will show the
welcome screen then with Language menu shown up, press the
buttons on the unit or press
language of your choice, then press VOLUME/SELECT/SNOOZE dial on unit or
SELECT button on remote control to confirm.
Then the privacy policy page will come up.
Please visit the website mentioned in the page for the details of the privacy poli-
cy. Press VOLUME/SELECT/SNOOZE dial on unit or SELECT button on remote
control to accept for next step.
1. To launch the initial Setup wizard, press the
unit or press
VOLUME/SELECT/SNOOZE dial on unit or SELECT button on remote control
to confirm.
2. Press the
remote control to select the following options, then press VOLUME/SELECT/
SNOOZE dial on unit or SELECT button on remote control to confirm the setting:
/
buttons on remote control to select [YES], then press
/
/
/
buttons on the unit or press
/
/
buttons on remote control to select the
/
38
/
/
buttons on the
/
buttons on
/
/
/