Essentiel FVPT 40 Bedienungsanleitung Seite 24

Fit the half ring to the inner tube. This is used to store the remote control on the unit (see
1.
Assembling the blades and guards
Unscrew the rotating part (3) and the nut (5) and remove them (see
2.
Place the rear guard (6) on the shaft (7) of the motor unit (8) with the handle upwards and screw the nut
3.
(5) back on to secure the rear guard (see
Fit the blades and screw the rotating part (3) back on.
4.
Place the front guard (1) on the rear guard and tighten the clamp by screwing in the screw at the
5.
bottom of the clamp with a Philips screwdriver (see
24
V.5.0
product sheet
Rotating part
Rotating
(on the back)
part
Tighten
Loosen
Nut
Notch for storing
the remote
control
Tighten
Slot
Shaft
Blades
7
).
figure
8
).
figure
figure
6
).
figure
5
).