Ottobock 17B203 Serie E-MAG Active Gebrauchsanweisung Seite 41

33
35
Insert the electronics into the receptacle (see fig. 36) and fasten with the enclosed screws (see fig. 37) at a maxim­
um torque of 1 Nm. Please observe the precise positioning of the electronics and the receptacle.
36
CAUTION
Risk of injury due to screws coming loose
The patient may fall and sustain injury if the bars loosen from the joint connections. Use a torque screwdriver for
tightening and secure with Loctite® 241.
NOTICE
Risk of damage to electronic components
Dust, moisture and heat may destroy the electronics.
► Always seal the electronics on the E-MAG knee joint before sanding or performing other work on the orthosis.
► Loosen bonded components mechanically. Do not use a hot air gun.
17B203=* E-MAG Active
34
1 2
4
37
Installation instructions
3
5
Ottobock | 41