Machine Settings - Electrolux Service 7000 Bedienungsanleitung

The consumption values have been established under standard conditions. They may deviate when
Programme
COTTON CUPBOARD DRY
COTTON IRON DRY
SYNTHETICS CUPBOARD DRY
1) different loading volume data may be needed in some countries as a result of different measuring methods
2) in accordance to EN 61121
3) hints for test institutes: cycle has to be checked in accordance to EN 61121

MACHINE SETTINGS

Setting
Buzzer permanent
on/off
1)
Water hardness
Emptying water res-
ervoir - warning
2)
off
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of
the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the
water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water reservoir is
full. When using an external drain for the condensed water warning can be offi
Consumption values
the machine is operated in domestic circumstances.
3)
3)
3)
1. Turn the programme selector to any programme.
2. Press simultaneously the Dryness (Trockengrad) and Spin Speed (U/
Min) buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use the buzzer option to
activate or deactivate sound but the machine does not memorise your
selection.
1. Turn the programme selector to any programme.
2. Press simultaneously the Dryness (Trockengrad) and Time (Zeitwahl) but-
tons and hold down for approx. 5 seconds. The current setting is on
the display:
–
low conductivity <300 μS/cm
–
medium conductivity 300-600 μS/cm
–
high conductivity >600 μS/cm
3. Press the Start/Pause button sequentially until you set desired level.
4. To memorise setting press simultaneously the Dryness (Trockengrad)
and Time (Zeitwahl) buttons or turn knob to Off (Aus) position
1. Turn the programme selector to any programme.
2. Press simultaneously the Spin Speed (U/Min) and Time (Zeitwahl) but-
tons and hold down for approx. 5 seconds.
The current setting is on the display:
– warning
– warning
Energy consumption in kWh / average dry-
1.9/ 135 (7 kg load pre-drained at 1000 rpm)
1.7 (7 kg load pre-drained at 1200 rpm)
1.65 (7 kg load pre-drained at 1400 rpm)
1.42 (7 kg load pre-drained at 1800 rpm)
1.4/ 106 (7 kg load pre-drained at 1000 rpm)
0.59/ 48 (3 kg load pre-drained at 1200 rpm)
Implementation
icon and - warning message is off
icon and - warning message is switched on
ing time in min.
65