Connecting The Steelhead Appliance To Your Network - Riverbed 60-Serie Erste Schritte

Installing the Steelhead Appliance (Steelhead, Steelhead CX, Steelhead EX)
The configuration wizard automatically starts when you log into the Steelhead command-line interface
for the first time.
Follow the prompts to configure network and in-path interface settings for the Steelhead appliance.

Confirm your settings; then type exit to log out of the system.


5. Connecting the Steelhead Appliance to Your Network

Make sure you use the correct cables to connect to your network:

– Straight-through cables: Primary and LAN ports to LAN switch.
– Cross-over cable: WAN port to WAN router.
Plug the straight-through cable into the Primary port of the Steelhead appliance and the LAN switch.

This can be any port on your LAN switch that is configured to connect to a host.
Identify the straight-through cable that connects your LAN switch to your WAN router; unplug the

end connected to the WAN router.
Plug the straight-through cable that you disconnected from the WAN router into the LAN port of the

Steelhead appliance.
Getting Started Guide
Installing the Steelhead Appliance
11