Installation Instructions; First Start - Brunner CLS-E RUDDER Kurzanleitung

2 INSTALLATION INSTRUCTIONS

GENERAL
Open the box carefully and remove all packaging.
The following material is included:
1. CLS-E Rudder
2. USB Cable
3. Power supply with cable
4. Hex bit screwdriver (5mm) for pedal plate angle setting
5. This manual
MOUNTING & OPERATING CONDITION
1. The unit must be mounted with 4 Screws (not
included) securely on a fl at surface before operating.
2. Keep a minimum of 5 cm distance around the unit
from any part.
3. Keep environmental temperature below 40°C max.
Use only in dry environment.

FIRST START

1. Connect the CLS-E Rudder with your computer
via the provided USB cable. See chapter 5
WIRING DIAGRAM on page 27.
2. Connect the provided power supply to Power Plug.
3. Connect the AC main power Plug. The calibration
and initialization sequence will start automatically.
Axis is moving across its range.
DO NOT DISTURB THIS SEQUENZ UNTIL THE PEDALS ARE CENTERED!
THIS SEQUENCE IS REPEATED EVERY TIME WHEN POWER IS APPLIED.
4