Anleitung RT 3525 SPK1
19.09.2006
GB
3. Symbols used on the appliance (see
Figure 2)
A: Warning!
B: Wear eye protection!
C: Protect from moisture!
D: Read the instruction manual before starting!
E: Pull out the mains plug before checking a
damaged power cable!
F: Keep other people out of the danger area!
G: The tool continues to run!
4. Technical data
Voltage:
230 V ~ 50 Hz
Performance
Cutting circle
Revolutions n 0
11.700 rpm
Cutting line
Sound pressure level L pA
Sound power level, L WA
Vibration a hv
Weight
The machine may exceed 85 dB (A). The operator
will require noise protection measures if this is the
case. The noise generated by this machine was
measured in accordance with EN 786.
The value of the vibrations emitted by the handle
was determined in compliance with EN 786.
5. Assembling the grass trimmer
Plug the two housing parts into each other (Fig.
2). Make sure that the cable is not jammed.
Note: After assembly, the housing parts can only
be taken apart with tools.
Plug the guard hood (7) on to the motor head
above the line spool (see marking in Figure 3).
Turn the guard hood clockwise through 90° to
the next mark (Figure 4) and secure with the
supplied screw (Figure 5). Note: When turning
the guard hood, make sure that it rests
horizontally on the motor housing.
12
15:23 Uhr
Seite 12
6. Proper use
The trimmer is designed for cutting lawns and small
areas of grass in private and hobby gardens.
Tools for private and hobby gardens are not suitable
for use in public facilities, parks and sport centers,
along roadways, on farms or in the forestry sector.
For the tool to be used properly it is imperative to
follow the instructions set out in the manufacturer's
directions for use.
Important! It is prohibited to use the tool to chop
material for composting because of the potential
danger to persons and property.
7. Starting up
350 W
The grass trimmer is designed only to cut grass. The
Ø 25 cm
grass trimmer has a semi-automatic line extension
system. Each time you activate the semi-automatic
line extension system, the line is automatically
Ø 1.2 mm
extended to ensure that you can cut your lawn with
73.8 dB
the perfect cutting width at all times. You can activate
96 dB
the line extension system with a short tap of the
machine against the ground.
≤ 2.5 m/s
2
Please note that the more often you activate the
1.6 kg
semi-automatic line extension system, the more the
line will wear.
Note:
If the line is too long when you use the machine
for the first time, the surplus end of it will be cut
by the blade on the safety hood.
If the line is too short when you start the machine
for the first time, press the knob on the line spool
and pull the line hard. When you then start the
machine for the first time the line will be cut to
the perfect length automatically.
To obtain maximum performance from your grass
trimmer, please follow the instructions given below:
Never use the grass trimmer without the guard.
Do not mow grass when it is wet. The best
results are achieved with dry grass.
Connect the power cable to the extension cable
and attach it in the handle (Fig. 6).
To switch on your grass trimmer, press the
safety ON/OFF switch (Fig. 1/Item 3).
To switch off your grass trimmer, let go of the
ON/OFF switch (Fig. 1/Item 3).
Do not allow the grass trimmer near the grass
until the switch is pressed, i.e. the grass trimmer
is in operation.