Installation; Electrical Connections - Hoshizaki FM-600AHE Installationsanleitung

ENGLISH
5) Remove the protective plastic film from the
panels. If the icemaker is exposed to the sun or
to heat, remove the film after the icemaker cools.
2. LOCATION
IMPORTANT
1. This icemaker is not intended for outdoor
use. Normal operating ambient temperature
should be within 5°C to 40°C. Normal
operating water temperature should be
within 5°C to 35°C. Operation of the
icemaker, for extended periods, outside
of these normal temperature ranges may
affect production capacity.
2. The icemaker should not be located next to
ovens, grills or other high heat producing
equipment.
3. The location should provide a firm and level
foundation for the equipment.
4. Allow 15 cm clearance at rear and sides
for proper air circulation and ease of
maintenance and/or service should they be
required. Allow 60 cm clearance on top to
allow for removal of the Auger.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. D o n o t p l a c e a n y t h i n g o n t o p o f t h e
icemaker or in front of the Louver.

3. INSTALLATION

* Incorrect installation can cause harm to people,
animals or things, for which the manufacturer
cannot be held responsible.
1) Fully screw in the four legs provided (bin
accessory) into the Storage Bin underside. See
Fig. 3.
Bottom Plate
Adjustable Legs
2) Position the Storage Bin in the selected
permanent site.
3) Place the icemaker on top of the Storage Bin by
holding the bottom.
4) Secure the icemaker to the Storage Bin, by
using the two mounting brackets and two bolts
provided. See Fig. 4.
Bolt
5) Seal the seam between the icemaker and the
Storage Bin with food grade sealant.
6) Refit the Side Panels in their correct position.
7) Adjust the four legs on the bottom (adjustable
from 0 to 25.4 mm) to have the icemaker
perfectly horizontal. Use the spirit level. See Fig.
5.

4. ELECTRICAL CONNECTIONS

THIS APPLIANCE MUST BE EARTHED
This icemaker requires an earth that meets
t h e n a t i o n a l a n d l o c a l e l e c t r i c a l c o d e
requirements. To prevent possible severe
electrical shock to individuals or extensive
damage to equipment, install a proper earth
wire to the icemaker. Disconnect the main
power supply before any maintenance, repairs
or cleaning is undertaken.
Fig. 3
* T h i s a p p l i a n c e r e q u i r e s a s e p a r a t e 2 2 0 -
240VAC, 20A (FM-600/FMN-440) / 13A (FM-481)
/ 10A (FM-251) supply. The electrical supply must
be protected by a suitable circuit breaker.
2
Icemaker
Bin
Mounting
Bracket
Adjust legs
WARNING
Fig. 4
Fig. 5