Setting The Analogue Output (Option); Start And End Value - WIKA DI35-D Betriebsanleitung

7. Description of program numbers
PN Function
15 Calculation type
EN
16 Constant
17 Number of decimal places of constants
18 Number of decimal places of calculation

7.4 Setting the analogue output (option)

The analogue output gives the measured values of the digital indicator as a standard
signal (DC 0 ... 10 V, 0 ... 20 mA, 4 ... 20 mA).

7.4.1 Start and end value

The analogue output can be assigned any measuring input. The output signal is
updated simultaneously with the measuring input. The refresh rate is determined by
the configured measuring time. The start and end value for the analogue signal can be
assigned user-defined measured values.
The start and end value defines at which display value the minimum and maximum
output signal will be given. The display value is dependent upon the setting of the input
signal ( see chapter 7.1.1 "Input signal")
PN Function
20 Full scale
21 Start value
28
With the calculation of the arithmetic function, all set decimal points are
included (PN 3, PN 8, PN 17, PN 18)
WIKA operating instructions digital indicator, model DI35-D
Parameter
1 = Measuring input 1 ∙ constant
2 = Measuring input 2 ∙ constant
3 = Addition
4 = Subtraction
5 = Multiplication
6 = Ratio
7 = Percent
-9999 ... 99999
00000 ... 0.0000
00000 ... 0.0000
Parameter
-9999 ... 99999
-9999 ... 99999