Danfoss HC6000 Installationsanweisungen Seite 4

Installation
GB
First remove the wallplate from the back of the unit.
From the top left hand corner of the wallplate, there must be
clearances of at least 140mm to the right, 15mm to the left,
30mm above and 100mm below in order to mount the plug-
in module.
Fix at a height of approximately 1.5m from the fl oor, away
from draughts or heat sources such as radiators, open fi res
or direct sunligh t.
Fit the thermostat to the wall and ensure the maximum cable
2
size is 1.5mm .
4