Installation Steps - Air Live WLA-5000APv2 Schnellinstallationsanleitung

Installation Steps

1. Please install your network cards first before the AP
2. Screw-in the antenna (clockwise) into the Antenna connector
3. Connect the power and LAN cable to the back
4. Use your wireless card to do a site survey, the default SSID is airlive
5. If you need to change AP's configuration, please follow the procedure
below:
The Client mode's default IP address is 192.168.1.2. Please
make sure your computer IP is in the same subnet as the AP (i.e.
192.168.1.x)
Open the web browser and enter 192.168.1.2.
Enter the Password airlive.
Changing Firmware
The default firmware is Client mode firmware,
If you need to use the AP+WDS or WISP Client Router mode feature, you
have to change the firmware. Please follow the instruction below:
1. Open your web browser, enter your AP's IP address (Client mode
default is 192.168.1.2).
2. When you are asked about the password. Please enter airlive in the
password field.
3. When the following screen appears. Please click on the System
Tools.
802.11 a/b/g Wireless AP
WLA-5000AP v2
English
2
2