Troubleshooting Guide - ROWENTA CT3808 Gebrauchsanweisung

ROWENTA THERMOS JUG
• Keeping warm:
Pre-heat the jug for a few minutes
with hot water, then pour out the hot
water.
Your isothermal jug will keep your
drink hot for 4 hours.

TROUBLESHOOTING GUIDE

Questions
- The ON signal will not turn off
immediately after the coffee
cycle ends.
- The on/off light fails to come
on.
- Water does not run through
completely.
- Increased noise level.
- The on/off light goes off while
the water is running through.
- The coffee does not flow into the
jug but the coffee-maker
functions
Subject to modification
Do not use it for soups or savoury
preparations.
• Keeping cold:
Cool the jug with cold water and
empty before filling with a cold
drink.
Possible causes
- As long as the coffee maker is
working normally, the signal
will turn off a few minutes after
the end of the cycle.
- Appliance is not correctly
plugged in.
- The button was not activated
correctly.
- Coffee-maker lined with scale.
- Thermal lid not fitted.
- The jug lid is clogged or the
filter-holder outlet is clogged.
- Lever not pressed sufficiently
(stainless steel jug).
- Lid is not unscrewed enough
(plastic jug).
- Hot air is compressing the lid.
9
Answers
- Wait for a few minutes after
the cycle ends until the ON si-
gnal turns off or press firmly
on the luminous switch to stop
your coffee maker.
- Plug in properly.
- Press firmly on the luminous
switch.
- Descale the coffee-maker.
- Put the lid in place.
- Clean the lid thoroughly with
soapy water or the filter-holder
outlet (Fig. 9 to 13).
- Press fully (stainless steel jug).
- Check the position of marker
- Press the dome cap on the lid
to reduce pressure.