Troubleshooting - ROWENTA CT500C Gebrauchsanweisung

Vorschau ausblenden

Inhalt

Inhaltsverzeichnis

Verfügbare Sprachen

cafetie?re silver art:0827963

PRIOR TO FIRST USE

Operate your coffee maker for the first time

without coffee with using 1 litre of water to

rinse the circuit.

MAKING COFFEE

(Follow the illustrations 1 to 7)

Only use cold water and a n°4 coffee filter

paper.

Do not fill beyond the maximum water

level marked on the water tank.

1 – Switching on your coffee maker:

For models with isotherm jugs, press the

transparent button. It will light up with a

white light and will return to its initial

position once it is released.

Note: Models equipped with an isotherm jug

have an automatic stop system at the end of

(LED lit

the cycle.

For models with pouring jugs, press the

transparent button. It will light up with a

white light and will remain in this position.

To switch off the machine, move the

button back to its initial position (the light

will be extinguished).

2 - For models with isotherm jugs:

To keep the jug warm longer, rinse it with

hot water prior to use.

The lid of the isotherm jug must be closed

tightly towards the left as far as possible

when making and keeping coffee hot,

figure 11.

To serve the coffee, press down the lever

on the lid isotherm jug, figure 10.

3 - For all models:

This coffee maker has a non-drip system

which allows you to serve a coffee before

all of the water has passed through the

filter. Place the pouring or isotherm jug

back in position rapidly to avoid any

overflows.

Wait for a few minutes before making

coffee again.

9/04/09

15:08

Page 8

CLEANING

To remove the used coffee, remove the

filter holder from the coffee maker, figures

8 and 9.

Unplug the appliance.

Do not clean the appliance when it is still

hot.

Clean with a soft cloth or a damp sponge.

Do not immerse the appliance in water or

place it under running water.

The filter holder is dishwasher-safe.

DESCALING

Descale your coffee maker every 40

cycles or so.

You can use:

•

either a sachet of descaler from the shops

diluted in ½ litre of cold water.

•

or 2 large cups of commercial white

vinegar available from hardware stores.

Pour the descaling solution into the water

tank (4) and switch on the coffee maker

(without any coffee in it).

Let half of the solution pour into the glass

or isotherm jug (7), then turn the

appliance off by pressing the "On / Off"

button, figure 7.

Leave to act for around one hour.

Switch the coffee maker on again and run

through the rest of the descaling solution.

Rinse the coffee maker by operating it 2 or

3 times with 1 litre of water and without

coffee.

T T h h e e g g u u a a r r a a n n t t e e e e d d o o e e s s n n o o t t c c o o v v e e r r c c o o f f f f e e e e

m m a a k k e e r r s s w w h h i i c c h h d d y y s s f f u u n n c c t t i i o o n n o o r r n n o o l l o o n n g g e e r r

f f u u n n c c t t i i o o n n d d u u e e t t o o a a l l a a c c k k o o f f d d e e s s c c a a l l i i n n g g . .

ACCESSORIES

Isotherm jug (CT500 or CT400 models)

Glass pouring jug (CG400 model)