Checking The Battery Charge Level; Starting Up; Operation; Switching On/Off - Parkside RAPIDFIRE 2.1 Originalbetriebsanleitung

Checking the battery charge
level
The battery's charge level is indicated by
the charge state indicator (
The state of charge of the battery is dis-
played by illuminating the appropriate LED
lights. In order to activate the display, the
on/off switch ( 9) must be pressed.
3 LEDs are on (red, yellow, green):
Battery charged
2 LEDs are on (red, yellow):
Battery partially charged
1 LED is on (red):
Battery needs to be charged

Starting up

Before the starting up must
the transport safety (
removed.
Open the transport safety (
move the transport safety of the bit holder
( 3).

Operation

Switching on/off

Press the on/off switch (
vice. To turn it off, release the on-off button.
If you move the direction switch (
the middle position, the device is secured
against being switched on.
The LED lamp can continue to be used by
activating the switch block. To do so, press
the on/off switch.
5).
1)
1) and re-
9) to start the de-
8) to

Direction switch

You can toggle between right (
( ) rotation by pushing the direction of ro-
tation switch ( 8).
If you move the direction switch (
the middle position, the device is secured
against being switched on.
The direction changed may
only be performed in stand-
still mode!
Bit selection from the bit
changeable drum
1. Push the slide of the interchange-
able cordless screwdriver (4)
forward.
2. Turn the bit changeable drum
(14) to the left or right until the
desired bit is located on top and
is in line with the bit holder (3).
The bit changeable drum en-
gages audibly.
3. Push the slide of the interchange-
able cordless screwdriver (4) to
the back.
Only grab the side of the
slide of the interchangeable
cordless screwdriver.
Caution, risk of injury caused
by pinching!
The selected bit is automatically fixed in
the bit holder ( 3).
Bit change in the bit
changeable drum
Remove the bit (
bit holder ( 3).
GB
) and left
8) to
2) from the
MT
61