Herunterladen Inhalt Inhalt Diese Seite drucken

Usel" Is Indicated On The Lcd Display And The Scales Switch Off; Err" Is Indicated On The Lcd Display; Err2" Is Indicated On The Lcd Display; Maintenance / Cleaning - Silvercrest SPWD 180 G1 Bedienungsanleitung Und Sicherheitshinweise

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
SilverCrest SPWD 180 G1

9.3 "USEL" is indicated on the LCD display and the scales switch off

An error has occurred and the diagnostic scales cannot perform the measurement. In this
case, step off the tread (5) of the diagnostic scales and start the measurement again.

9.4 "Err" is indicated on the LCD display

Your weight exceeds the maximum load capacity of 180 kg / 396 lb / 28 st. You should
step off the tread (5) of the diagnostic scales immediately to avoid damaging the scales.

9.5 "Err2" is indicated on the LCD display

An incorrect measurement has occurred. In this case, step off the tread (5) of the diagnostic
scales and start the measurement again. Make sure that you are standing on both electrodes
(6).

10. Maintenance / cleaning

It is necessary to service the diagnostic scales if they have been damaged in any way, for example,
if the housing is damaged, if liquid or objects have penetrated the diagnostic scales or if they have
been exposed to rain or moisture. Servicing is also required if the device is not working properly or
has been dropped. If smoke is produced, or there are any unusual sounds or smells, remove the
battery immediately from the diagnostic scales. In such cases, the diagnostic scales should not be
used until they have been inspected by authorised service personnel. Only have qualified personnel
carry out the servicing on the device. Never open the housing of the diagnostic scales. Only use a
clean, dry cloth for cleaning and never use any corrosive liquids.

11. Environmental and disposal information

When the crossed out wheelie bin symbol appears on a product, this indicates that the
product is subject to the European Directive 2012/19/EU. All old electrical and
electronic devices must be separated from normal household waste and disposed of at
designated state facilities. The correct disposal of old devices in this manner will
prevent environmental pollution and human health hazards. The battery must be
removed from the device before it is scrapped.
For further information about proper disposal, contact your local authorities, waste
disposal office or the shop where you bought the device.
28 - English

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis