SilverCrest SPWG 180 E5
Troubleshooting
Nothing is indicated on the LCD display.
The lithium battery CR2032 is empty. Replace the lithium battery CR2032 with another of the
same type. Please note the instructions in the section "Replacing the battery".
The lithium battery CR2032 is inserted incorrectly. Please note the instructions in the section
"Replacing the battery".
"Lo" is indicated on the LCD display and the scales switch off.
The lithium battery CR2032 is almost empty. Replace the lithium battery CR2032 with
another of the same type. Please note the instructions in the section "Replacing the battery".
"USEL" is indicated on the LCD display and the scales switch off.
An error has occurred and the bathroom scales cannot measure your weight. In this case,
step off the tread (2) of the bathroom scales and step on it again. The weight measurement
starts again.
"Err" is indicated on the LCD display.
Your weight exceeds the maximum load capacity of 180kg / 396lb. You should step off the
tread (2) of the bathroom scales immediately to avoid damaging the scales.
Maintenance / cleaning
It is necessary to service the bathroom scales if they have been damaged in any way, for example,
if the housing is damaged, if liquid or objects have penetrated the bathroom scales or if they have
been exposed to rain or moisture. Servicing is also required if the scales are not working properly
or have been dropped. If smoke is produced, or there are any unusual sounds or smells, remove
the battery immediately from the bathroom scales. In these cases, the bathroom scales should not
be used until they have been inspected by authorised service personnel. Only have qualified
personnel carry out the servicing on the device. Never open the housing of the bathroom scales.
Only use a clean, dry cloth for cleaning and never use any corrosive liquids.
22 - English