Inhaltsverzeichnis
Werbung
CERTIFIED APPLICATIONS
WRAS Approval No: 1209110
BuildCert Certificate No: BC1002/0512
Certified Applications
H9600 Flexible tails fixed
H9605 Flexible tails Bioclip
H9600610 Copper tails fixed
H9605610 Copper tails Bioclip
Complies with the NHS Model Specification DO8, designation HP-WE when operated as set
out in Table 1 below.
Operating Pressure Range
Maximum pressure - Bar
Flow pressure, Hot and cold - Bar
Hot Supply Temperature - °C
Cold Supply Temperature - °C
Mixed Water Temperature - °C
OPERATION & TECHNICAL INFORMATION
How to operate (Fig. A):
• In position (1-a), the single lever thermostatic mixer is closed.
• When the control lever (1) is turned clockwise, the mixer will start to deliver cold water at the temperature
of the cold water supply in position (1-b). Continue turning the control lever (1), and the water will get
progressively hotter up to position (1-c), which is the maximum hot water position.
• The maximum temperature is pre-set at the factory between 39°C and 41°C with the following parameters:
hot and cold water pressures are balanced at 3 bar dynamic pressure; hot water temperature at
65°C +/- 5°Cand cold water temperature at 15°C +/-5°C.
Technical Characteristics (Fig. B):
> Flow rate:
- Mixed water temperature 39°C at 3 bar pressure: 6.5 litres/min.
- Mixed water temperature 39°C at 1 bar pressure: 4.5 litres/min.
- If the pressure is at 0.5 bar, the flow rate will be 3.5 litres/min.
> Safety:
- If the cold or hot water fails, the mixed water will shut-off within 2 seconds.
- The anti-scalding safety is active if the temperature differential between the hot water and mixed water
is more than 15°C.
- Check the anti-scalding failsafe every two months and as often as necessary depending on the
water quality. Shut-off the cold water and check that the hot water stops within 2 seconds.
When using a filtration device or similar system at the spout outlet or shower head, the flow rate must
be higher than 4 litres per minute to avoid cross flow between the hot and cold water.
Note: The anti-scalding safety is active if the cold water supply fails. If, instead of cold water, hot water
returns through a mechanical mixer, there is no anti-scalding safety. We recommend installing
a non-return valve on the cold water supply to the mechanical mixer.
High Pressure Systems
10
1 to 5
52 to 65
5 to 20
41
Low Pressure Systems
10
0.2 to 1
52 to 65
5 to 20
41
EN
Werbung
Inhaltsverzeichnis
