General Safety Instructions - Cleco 55 Serie Bedienungsanleitung

823104-LG1
11/23/2016
For this Instruction Manual
The original language of this manual is English and is
intended for all persons who will operate and maintain this
equipment.
This instruction manual has the following purposes:
• It provides important instructions for safe and effective
operation.
• It describes the function and operation of this equipment.
• It serves as a reference guide for technical data, service
intervals, and spare parts ordering.
Symbols in the text:
→ Identifies instructions to be followed.
• Identifies a list.
Bold Indicates an important feature or instruction.
Identification graphic:
Indicates a directional movement.
¢
Indicates a function or force.
ò
Copyright protection:
Apex Tool Group, LLC reserves the right to modify,
supplement or improve this document or the product without
prior notice. This document may not be reproduced in any
way, shape or form, in full or parts thereof, or copied to
another natural or machine readable language or to a data
carrier, whether electronic, mechanical, optical or otherwise
without the express permission of Apex Tool Group, LLC.
Safety:
Warnings and notes
Warning notes are identified by a signal word and a
pictogram.
• The signal word indicates the severity and probability of
the impending danger.
• The pictogram indicates the type of danger.
-------------------------------------------------------------
Indicates a potentially hazardous situation
for personal health and safety. If this warning
is not observed, death or serious injury may
occur.
-------------------------------------------------------------
Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderate injury or property and environmental
damage.
-------------------------------------------------------------
GENERAL NOTE identifies useful information
that may include application tips but no
hazardous situations.
-------------------------------------------------------------
EN
Symbols on product
Be sure you understand their meaning before using this
equipment.
-------------------------------------------------------------
Read all instructions
-------------------------------------------------------------
Eye protection must be worn at all times during
the operation or maintenance of this tool.
-------------------------------------------------------------
Eye protection must be worn at all times during
the operation or maintenance of this tool.
-------------------------------------------------------------
CE compliant
-------------------------------------------------------------
EurAsian conformity
-------------------------------------------------------------

General Safety Instructions

Designated Use
A pneumatic assembly tool is to be used only for tightening
of threaded joints or running down fasteners using industrial
power tool type drive sockets or bits.
Never use hand tool type sockets or bits with
an industrial power tool. Hand tool sockets or
bits can break resulting in a hazard of flying
pieces.
Do not modify the tool, any guard, or accessory unless
approved in writing by Apex Tool Group, LLC. All safety
devices must be properly installed and maintained in good
working order.
Any abuse or misuse of this tool, drive
sockets, bits, or accessories can be extremely
dangerous. We recommend the use of Apex®
brand drive sockets and bits manufactured by
Apex Tool Group, LLC.
Putting into service
Only fully trained personnel should install, adjust, operate,
or repair this tool.
Air supply
Connect the tool to a clean lubricated air supply capable
of providing a measured maximum air supply of 90 psig at
the tool with the tool running and the lever fully depressed.
Make certain an air shut off valve is installed within reach of
the tool's workspace.
Page 4