Marmitek easy icon 10rf Gebrauchsanleitung Seite 9

you can easily change these names by selecting Home/Setup/Favourites/Rename or
Home/Setup/X10/More Rename.
LEARNING
For the EasyIcon10RF to learn from another remote, do the following:
• Place the 2 remotes on a flat surface (table).
• Ensure that the transmitter end from the original remote is 40 mm
or so away from the receiving end (bottom)
of the EasyIcon10RF.
• Press the key/button on the original remote that you want to learn
from for about a second and release it (press and release).
• Do not press and hold it for an extended period of time.
You can learn commands from an existing remote and store them
under the "Main" Keys on the EasyIcon10RF, or learn commands from
an existing remote and store them under any of the 10 Side Keys.
At the HOME screen press the Side Keys next to Setup, More, and Learn.
The next screen asks, "Where do you want to learn?" The question
means, do you want to learn a command and place it on a Side key of
the EasyIcon10RF, or do you want to learn a Main Key command and
place it on a Main Key of the EasyIcon10RF.
If you press a right Side Key (to select Main Keys) you are going to learn,
say, the Chan Up key from an existing remote and store it under the
Chan Up key on the EasyIcon10RF.
Or, learn the Power key from an existing remote and store it under the
Power key on the EasyIcon10RF, etc.
Select the Device you want to learn keys for. In this example we only have
a TV, Cable Box and Satellite Receiver set up, so the rest are grayed out,
but you can still select any of the devices to learn commands for. You are
then instructed to line up the remotes, and press the key on the
EasyIcon10RF remote that you want to learn, e.g., the Power key.
Then, point the remote you want to learn commands from at the bot-
tom of the EasyIcon10RF. Press and hold (in this example) the Power
key on the other remote until the display shows that the command has
been successfully learned. Note for some types of keys you might need
to hold the key pressed, but for other types a quick press is sufficient.
Experiment a bit. If keys you learn are sent multiple times try learning
them with just a quick press.
If the screen says Failure, you can press the key and try again.
EASY ICON 10 RF™ 9