Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mode 2: Spot cleaning
Press SPOT on the remote control to start spot cleaning.
NOTE: only use this mode on areas with a lot of dust/dirt.
When the dusty area is cleaned, the robot will automatically turn to
AUTO mode.
Mode 3: Edge cleaning
Switch the robot on, press MODE on the remote control and select
mode 3 (Edge cleaning). The robot will now clean along obstacles by
using its side brushes.
Mode 4: Zig-Zag cleaning
When the robot detects an open area it will automatically turn into
Zig-Zag mode.
Mopping + Watertank
The principle of overflow water tank
Water flows out of the water tank automatically due to gravity, so
please take out the water tank after finishing cleaning.
Water Tank and Mopping Cloth Installation
1. Install mopping cloth
Stick mopping cloth on the bottom of water tank as shown in fig 1.
Make sure the sticking side and mopping cloth face the appropriate
sides, and then stick the mopping cloth on its sticking side.
2. Fill water tank with water
Take out rubber plug of water tank, fill it with water, and then put back
the rubber plug tightly in position to prevent water leakage.
3. Fix water tank on the robot
Turnover the robot, fix the water tank on the robot bottom. Make sure
the bolts are firmly pressed into the fixing slots.
CLEANING AND MAINTENANCE
Side brushes
Dust bin and filter
•
Make sure you regularly empty the dust container and clean the
filter
•
Keep the device over a bin and press the unlock button of the
dust container.
•
Remove the filter holder from the dust container and beat them
clean.
•
If the filter is very dirty you can clean with a brush, a vacuum
cleaner, or rinse with lukewarm water.
•
Never immerse the device under water, the device and the
various parts are not dishwasher-proof.
•
Never block the outlet openings during vacuuming.
•
Never vacuum flammable liquids.
Instruction manual
EN
9
Werbung
Inhaltsverzeichnis
