. Setting; Setting Of The Auto Lifter Function - JUKI DLN-6390 Betriebsanleitung

_. SETTING �� SC�921
1. Setting of the auto lifter function
WARNING :
When the solenoid is used with the air drive setting� the solenoid may be burned out. So� do not
mistake the setting.
When the auto-lfter devce (AK) s attached, ths functon makes the functon of auto-lfter work.
1
3
2
FL ON : Auto-lfter devce becomes effectve. Selecton of the auto-lfter devce of solenod drve (+33V) or of ar
drve (+24V) can be performed wth
(Changeover s performed to drve power +33V or +24V of CN37.)
Solenoid drive display (+33V)
FL OFF : Auto-lfter functon does not work. (Smlarly, the presser foot s not automatcally lfted when programmed
sttchng s completed.)
(Caution) 1. To perform re�turning �N of the power� be sure to perform after the time of one second or more
has passed.
(If �N / ��� operation of the power is performed quickly� setting may be not changed over well.)
2. Auto�lifter is not actuated unless this function is properly selected.
3. When "�L �N" is selected without installing the auto�lifter device� starting is momentarily
delayed at the start of sewing. In addition� be sure to select "�L ���" when the auto�lifter is
not installed since the touch�back switch may not work.
44
A
4 5
6
) Turn ON the power swtch wth
B
5 held pressed.
2) "FL ON" s dsplayed on ndcators A and
B wth a blp to make the auto lfter functon
effectve.
3) Turn OFF the power swtch, and turn ON
the power swtch agan to return to the
normal mode.
4) Repeat the operaton ) to 3), and LED
dsplay s turned to (FL OFF). Then, the
functon of auto-lfter does not work.
7
swtch 6 .
Air drive display (+24V)
swtch