Installation And Setting Sc-921 - JUKI MF-7200D series Betriebsanleitung

4. Installation and setting SC-921
(1) Table-mount type
* The nstructons apply to the case the control box s nstalled on the table of the MF-7200D.
To use any other machne head, nstall the control box on the table referrng to the Instructon Manual for
the man body of the relevant sewng machne.
Convex
washer
Spring
Hexagonal
washer
nat
3
6
1) Install control box 2 and sensor bracket 3 on the table with fitting bolt asm. 1 suppled wth the unt as ac-
cessories. At this time, insert supplied nuts and washers as shown in the figure so that the control box and
sensor bracket are securely fixed.
2) Install the control box (or the one equpped wth a small szed motor unt) on the table. Then, nstall the sew-
ng machne head on the table. (Refer to the Instructon Manual for the sewng machne.)
3) Install the mountng plate on the CP-18 panel wth four tappng screws 4 suppled wth the unt.
At ths tme, take care not to allow the cable to be caught under the mountng bracket.
4) Install CP-18 panel 5 and sensor bracket 3 on the table wth wood screws 6 .
(2) Semi-sunken type
3
1) Install control box mountng plate 1 on the SC-921 wth four screws 2 .
2) Install the aforementoned assembly on backng plate 4 wth four screws 3 .
2
1
2
– 4 –
1
6
5
6
4
1
4