Installation Without A Rack; Rack Mount Installation - Sony IPELA NSRE-S200 Installationsanleitung

When the front bezel is opened
19.4 in. (494 mm)
4.6 in.
(117 mm)
4.2 in.
(106 mm)
18.9 in. (479 mm)
4.0 in.
(102 mm)
You can install the unit on a rack using the optional rack
mounting kit.

Installation Without a Rack

Attach the provided rubber feet to the recorder.
Place the recorder upright so that the bottom surface is
visible. Then affix the adhesive surfaces of the rubber
feet on the bottom of the recorder as illustrated below.
Remove
the film
Rubber
foot
Bottom of the unit
14.8 in. (377 mm)
14.8 in. (377 mm)

Rack Mount Installation

Install the unit in a rack using the optional rack
mounting kit (sold separately).
Warning
• Do not use a rack mounting kit other than the optional
mounting kit (sold separately) for the unit, as doing so
is dangerous and may result in fire, shock, or injury.
• If you mount the unit in a rack, make sure not to place
heavy object on it.
• Before mounting the unit in a rack, we recommend
that you mark its intended position in the rack with a
felt-tip pen. Mounting the unit in the rack other than
horizontally could result in malfunctions.
• To order a rack mounting kit, contact your retailer.
Pulling Out the Inner Rails
Pull out the inner rails from the rail assemblies.
1
Pull out the inner rail from one of the rail
assemblies as far as it can go.
Back of rail assembly
Rail assembly
2
Turn the rail assembly over. As you pull the green
tab outward to release the lock, pull the inner rail all
the way out.
3
Repeat the same procedure with the other rail
assembly to pull out its inner rail.
Note
The inner rail will be installed on the unit, while the
rail assembly will be installed on the rack.
Inner rail
Green tab
9
Installation