Assembly; Preparation; Making Ice Cream - Silvercrest SECM 12 B5 Bedienungsanleitung

Assembly

Use the diagrams on the fold-out page as a guide
for assembly!
1) Remove all packaging materials and any
stickers from the appliance.
2) Clean the appliance as described in the
section "Cleaning and Care".
3) Place the freezer bowl
4) Insert the drive shaft
recess on the ice scraper
scraper clicks into place.
5) Insert the other end of the drive shaft
the corresponding drive shaft socket
6) Put the lid on the freezer bowl
that the ▼ arrow on the lid
symbol on the freezer bowl
in either direction until the ▼ arrow on the
lid is pointing to one of the symbols on
the freezer bowl
7) Insert the plug into a mains power socket.
The appliance is now ready for use.

Preparation

♦ Place the freezer bowl
for about 24 hours at a temperature of no more
than –18 °C.
TIPS
► Make sure that the freezer bowl
pletely dry before you place it in the freezer.
► Place a plastic bag, for instance a freezer
bag, in the freezer bowl
► Keep the freezer bowl
freezer.
► Store the fruit, milk and cream in the refrigera-
tor before processing. This ensures that they
are already cold and thus the ice cream
mixture will not require so long to cool down
the ingredients.
SECM 12 B5
on a flat surface.
into the corresponding
until the ice
into
.
. Ensure
is pointing to the
. Turn the lid
.
in the deep freeze
is com-
before freezing.
upright in the
♦ Puree the fruit with a hand blender and mix all
the ingredients as described in the recipe.
♦ Allow the mixture to cool down for approx.
4 hours.

Making ice cream

CAUTION! PROPERTY DAMAGE!
► Start the appliance first and then add ingre-
dients. Otherwise, the ice mixture will freeze
onto the sides of the freezer bowl
block the ice scraper
motor to overheat!
► Do not stop the appliance during processing!
Otherwise, the ice mixture will freeze onto
the sides of the freezer bowl
scraper will be blocked when you switch
the appliance back on. This will cause the
motor to overheat!
1) Remove the freezer bowl
2) Assemble the appliance as described in the
chapter titled "Assembly".
3) Switch the appliance on by moving the On/
Off switch to the position I. The whisk
starts to turn.
4) Now, fill the prepared ice mixture into the
freezer bowl through the filling opening
Ideally, use a bowl with a spout. Never add
more than 1000 ml. During processing, the
mixture increases in volume!
5) Allow the appliance to continue running until
you are satisfied with the consistency of the
mixture. The ice cream is ready after 40 min-
utes at the most.
6) Switch the appliance off at the On/Off switch
and pull the mains power plug out of the
socket.
7) Turn the lid until you can take it off.
8) Pull the ice scraper
If the ice cream sticks to it, scrape it off with a
plastic spoon or similar tool.
and
. This will cause the
and the ice
from the freezer.
out of the ice cream.
GB │ IE │ NI │ CY │
.
5 ■