Assembly; Preparation - Silvercrest SEMD 12 A1 Bedienungsanleitung

Assembly

Use the diagrams on the fold-out page as a guide
for assembly!
1) Remove all packaging materials and any stickers
from the appliance.
2) Clean the appliance as described in the section
"Cleaning and Care".
3) Place the base 0 on a fl at surface.
NOTE
► Always put the appliance together in the or-
der described in this section. Otherwise some
parts may not fi t together correctly.
4) Place the two beakers 8 onto the hexagonal
bases so that the handles of the beakers 8
face outwards.
5) Insert the two ice scrapers 7 into the recesses
in the beakers 8. The drive shaft sockets 6
must be facing upwards.
NOTE
Ensure that the rotary switch 9 is set
►
when removing or replacing the lid 5.
to
6) Place the lid 5 on the beakers 8. Ensure that
the drive shaft sockets 6 are sticking up through
the holes in the lid 5.
SEMD 12 A1
7) Turn the rotary switch 9 to the position
The lid 5 can now no longer be removed.
8) Insert the two drive shafts 3 into the hexagonal
holes on the motor unit 2.
9) Place the motor unit 2 onto the lid 5 so that
the power cord is facing to the rear. The drive
shafts 3 must be correctly inserted into the
drive shaft sockets 6.
10) Insert the plug into a mains power socket.
The appliance is now ready for use.

Preparation

Place the two beakers 8 in the deep freeze for
♦
about 8–12 hours at a temperature of no more
than -18°C.
TIPS
Keep the beakers 8 upright in the freezer.
►
Ensure that the beakers 8 are completely
►
dry before you place them in the freezer.
► Place a plastic bag, for instance a freezer
bag, in each beaker 8 before freezing.
► Before processing, place the fruit, the milk
and cream in the fridge. This ensures that the
fruit is already cold and thus the ice cream
mixture will not require so long to cool down.
♦ Puree the fruit with a hand blender and mix all
the ingredients as described in the recipe.
♦ Allow the mixture to cool down to about
5–10°C in the fridge.
.
GB
IE
5