miniland baby digimonitor 2.4" plus Bedienungsanleitung Seite 41

6. MAINTENANCE
• Clean the surfaces of the camera and monitor with a soft, lint-free cloth.
• If the units become dirty, use a lightly dampened cloth to wipe surfaces, taking care to not allow
water into any openings.
• Never use cleaning agents or solvents.
7. TROUBLESHOOTING
Problem
No reception on the
monitor
Only black and white
images are displayed
The camera does not
transmit
You cannot hear the
baby on the parent unit
Interference or poor
reception
Possible Cause
Camera not turned on
Monitor not turned on
Camera: not plugged in to the
power adapter
Monitor: The power adapter is
not plugged
Monitor out or range
Connection lost between the
monitor and a camera already
linked
A wrong camera has been
selected
Check whether the camera is
in night vision/infrared mode
The camera is not turned on
Camera: the power adapter is
not plugged in
VOX mode or Standby mode
are active
The volume setting of the
parent unit is too low
Other electronic devices may
be interfering with the signal
The camera and monitor may
be too far apart
The battery power may be too
low
Solution
Press and hold down button (III) for
2 seconds
Press and hold down the Power
button (12)
Plug in the power adapter
Plug in the power adapter
Move the monitor closer to the
camera
Link the camera with the monitor
again. See 5.2.9.1.4
Change the camera number you are
watching. See 5.2.9.1.1
In order to view the images in colour,
increase the level of light in the room
the camera is in or check there is
nothing covering the camera´s light
sensor (II).
Press and hold down button (III) for
2 seconds
Plug in the power adapter
To see
continuously, disconnect the VOX or
Standby mode on the Monitor
Set the volumen to the highest level
Move them away from the device
Move the monitor closer to the
camera
Plug in the power adapter
41
ENGLISH
the monitored area